Product parameters

● The main is scoring and slitting on corrugated board.

● The structure is double scoring devices and adds one slitting system.

● Slitting capacity: 4 out (slitting wheel: 5 sets, and scoring wheel: 2 sets and total is 8 scorings).

● 5 out (slitting wheel: 6 sets, and scoring wheel: 2 sets and total is 10 scorings).

● 6 out (slitting wheel: 7 sets, and scoring wheel: 2 sets and total is 12 scorings).

● Slitting and scoring use precise linear bearing.

● Single blade use down slitting design, diameter 270mm, and upper scoring device urethane.

● Minimum slitting size: 120mm.

● Down slitting type can effectively improve corrugated paperboard's fish-tail problem.

● Each blade using independent motorized motor can independently adjust blade entry amount.

● Using gradually blade entry, which set by corrugated board's thickness. (signal sent from production management system).

● Each blade has independent grinding and oil fill system, which can be set automatic grinding time and length by computer; also can do by manual.

● In order to make sure corrugated board's cut smoothly.

● Diameter of scoring wheel: 224mm.

●Minimum scoring size: 0mm.

● The height of lower scoring roller can not be adjusted, and up and down of upper scoring wheel adjusted by air cylinder with scoring depth control system.

● Slitting and scoring diameter adjusted by motorized motor, and the size adjusted within 1-13 seconds.

● Up to 999 orders can be stored into memory, and output any order according to the demand.

● Machine can right or left move 75mm to fit with web edge-guide.

●With motorized web suction equipment(pre-set by computer).

● A.C. motor +electric converter for slitting wheel, and ally with double facer.

● Two units ally machines used change order without cutting off paper board or stopping machine.